Solar Studs need to be lit every day, and the lighting time is long. If the quality is not good, not only people are not satisfied, but the repair of
Solar Studs is also a considerable task. The lighting rate of
Solar Studs is one of the important goals. Then you should grasp the following key links when you start to buy
Solar Studs lights.
The first acquisition was
Solar Studs, which is a very important part, Chen said. When bidding, each company provides
Solar Studs light attenuation inspection of different companies, some provide self-inspection by their own company, and some provide inspection by a third party. Although the inspection results here are good, the actual light attenuation in practice is very different. Big, we know the reason, how can we know the truth?
The first is the designated body recognized by the Semiconductor Alliance. For example, Beijing
Solar Studs Light Source Quality Monitoring and Testing Center, Shanghai
Solar Studs Light Source Quality Monitoring and Testing Center, and the Thirteenth Institute of Semiconductors, etc., these units test and report that the
Solar Studs light decay is reliable, and the use of
Solar Studs for road lighting has high power and large heat generation. The attenuation detection has clarified two problems: the
Solar Studs is qualified for light attenuation and the power supply is qualified. If
Solar Studs doesn't close in the lab, does departure guarantee quality?
After the
Solar Studs recession check, the structure is a big problem. This problem is rarely paid attention to in the industry, and it is also one of the primary reasons why
Solar Studs is used in practice.
As we all know, the area of smog in the country is so large, which not only causes damage to the human body, but also the decline of
Solar Studs, especially in the northern region, where there is a lot of dust and smoke. After a period of outdoor use, the overall appearance of
Solar Studs is full of dust and heat dissipation. The effect is greatly reduced. This is also one of the main culprits that
LED Solar Studs are not known for.
According to this situation, the lighting plan must be transparent from top to bottom. The doubling of the heat dissipation area is because which
Solar Studs processing department did not arrange the radiator on time, and it can only be cleaned by rain in long-term use. After the area is increased, the effective heat dissipation area is also reduced due to pollution.
Solar Studs lighting recession has a barrel effect, and there are shortcomings. Light recession has plagued us for so many years. The problem here is that
Solar Studs light decay can be dealt with if the heatsink of the light fixture is handled well. Otherwise, we've been commenting on bullet-type packages with low-power chips from the past, but high-power chips won't do. The power of the chip says that the heat will not dissipate. Otherwise, the COB package heat is more suitable, and the thermal conduction problem can be completely handled by the aluminum bracket and the copper bracket.
However, the reason why
Solar Studs light attenuation is difficult to control is because the heat sink treatment may not be able to deal with the problem of
Solar Studs light attenuation. There is a great misunderstanding of the
Solar Studs light source package. The silica gel of the COB light source is too thick. The thinner the silica gel package, the better. The easier it is to dissipate heat from the light-emitting surface of the chip, which is why the light attenuation of COB
Solar Studs cannot be controlled.
