< img height="1" width="1" style="display:none" src="https://www.facebook.com/tr?id=318636409624663&ev=PageView&noscript=1" />
Home
About
Products
Application
Exhibition & news
VIDEO
CONTACT
English
English Spanish

Common problems during installation of solar Road Studs (1)

Date:2022-08-25
Solar Road Studs can well outline the outline of the road and greatly improve the safety of driving at night. A good solar Road Studs should have three elements during use: pressure resistance, continuous highlighting, and firm installation.

Most people pay attention to the first two points in the process of use, while ignoring the problem of solar Road Studs installation, and the result is a high drop-off rate in a short period of time. A firmly installed solar Road Studs should pay attention to the following points:

position:
The road where the solar road studs are installed should be flat and clean, so that the bottom surface of the solar road studs can have a large contact area with the ground surface, and the adhesion is greatly increased.

Glue:
Glue is selected. At present, asphalt glue and epoxy resin glue are mainly used in China. The advantage of asphalt glue is that the curing time is short, but it has a fatal disadvantage: in summer, when the surface temperature reaches 70-80 degrees, it will soften, and when the wheel hits, it will either fall off or stick the softened black asphalt glue on. The surface of the reflective sheet affects its reflective effect. Therefore, epoxy glue must be used to install Road Studs. There are no less than 100 kinds of epoxy resin glues on the market, but there are only two or three kinds of epoxy resin glues suitable for Road Studs, and the ratio with the curing agent must be reasonable.
Copyright © Henan Ruichen Traffic Equipment Co., LTD All Rights Reserved
   Privacy Policy    Technical Support :coverweb
whatsapp
Phone
Email