With the popularity of solar energy, more and more people choose to buy
Solar Road Studs to use in their garden villas. However, for ordinary consumers, the working principle of
Solar Road Studs is not very familiar, which may lead to some misunderstandings during use. Because, below, I have listed some precautions in the use of
Solar Road Studs for everyone.
1. When installing, the photovoltaic panels should be exposed to sunlight as much as possible.
Solar Road Studs, as the name suggests, use solar energy, and it must be ensured that the sunlight can directly hit the photovoltaic panels in order to absorb energy and power the lamps.
2. If the photovoltaic panel has a protective film or the like, it should be removed. Many consumers easily overlook this point. The protective film covering the photovoltaic panels of
Solar Road Studs must be torn off, otherwise the efficiency of photovoltaic panels to absorb sunlight will be greatly reduced.
3. The wires between
Solar Road Studs photovoltaic panels and lamps are divided into positive and negative poles, and cannot be reversed. Make sure that the wire connectors are connected in place. If the photovoltaic panel and the lamp are not connected well, the solar energy received by the
Solar Road Studs photovoltaic panel cannot be transmitted to the battery in the lamp for storage through the wire, resulting in the lamp not turning on without electricity.
4. If conditions permit, clean up the fallen leaves, dust and stains on the surface of
Solar Road Studs photovoltaic panels in about three months.
5. The
Solar Road Studs light control program is given priority. Many remote controls are provided to facilitate turning off the lamps during transportation. The
Solar Road Studs remote control has little effect in actual use, and is basically unnecessary except for debugging during installation.
