1. Before installing
Solar Road Studs, it is very important to place safety isolation facilities. I hope you can't ignore it, and during the whole dynamic construction process, whether it is a new road or a road that has been opened to traffic, everyone It should be in a safety facility, such as construction on a road open to traffic, the ratio of safety personnel to installation personnel should be 1:1. The ratio of safety personnel to installation personnel should be 1:3 for the construction of road sections that are not open to traffic.
2. Determine the installation position of the
Solar Road Studs, and ensure that the installation position of the
Solar Road Studs is flat. For the pavement with expansion, cracks and unevenness, the pavement should be leveled in advance.
3. Use a brush to clean the location where the
Solar Road Studs are installed, and make sure that the location where the
Solar Road Studs is installed is dry.
4. Take an appropriate amount of glue and spread it evenly on the
Solar Road Studs.
5. Press the
Solar Road Studs firmly on the installation position to ensure the correct direction. If there is too much glue, be sure to clean it up;
6. If it is cast
aluminum Solar Road Studs with feet, make sure that the depth of the hole is 25px greater than the depth of the foot, and the diameter of the hole is 2mm greater than the diameter of the foot.
7. After the installation of Solar Road Studs, an inspection shall be made within two hours to ensure that all
Solar Road Studs are not installed backwards, installed crookedly or pressed crookedly.
8. After the road studs are cured for 4 hours, remove and install the isolation facilities.
Solar Road Studs installation is not a complicated affair, but there are many details to pay attention to. These details play a very important role in ensuring the quality requirements and service life of
Solar Road Studs.
