How to install
Solar Road Studs? I believe this is a question that many people want to know. Today Ruichen brought the installation guidelines for
solar street lamps, hoping to solve your problems.
Installation instructions for
Solar Road Studs:
⒈Fix the components of each part: the solar panel is fixed on the solar panel bracket, the lamp head is fixed on the pick arm, then the bracket and pick arm are fixed to the main pole, and the connecting wire is passed to the control box (battery box).
⒉ Before installing
Solar Road Studs, check whether the fasteners of each part are firm, whether the lamp head is installed correctly, and whether the light source works normally. Then check whether the simple debugging system works normally; loosen the connecting wire of the solar panel on the controller, and the light source works.
⒊
Solar Road Studs pay attention to safety precautions; the screws are well tightened, if the sun angle of the component is deviated, you need to adjust the sun direction to the south.
⒋Put the battery into the battery box, and connect the connecting wire to the controller according to the technical requirements; connect the battery first, then the load, and then the solar panel; when wiring, be sure to pay attention to the connection between each wiring and the terminals marked on the controller. If the connection is wrong, the positive and negative polarities cannot collide and cannot be reversed; otherwise, the controller will be damaged.
⒌Check whether the system works normally; loosen the solar panel cable on the controller, the
Solar Road Studs is on; connect the solar panel cable, the lights are off; at the same time, carefully observe the changes of the indicators on the controller; everything is normal, Seal the control box.
