The following precautions should be taken when installing
Solar Street Lights to ensure their normal operation and extend their service life:
Installation location and direction:
1. The solar panels of
Solar Street Lights need to face the south direction to absorb light energy to the maximum extent.
2. Avoid installing around tall buildings, plants, electric poles, etc. to ensure the duration of light source exposure.
3. The installation location should at least ensure that the upper part of the solar panel is open and there are no obstacles to ensure that it can receive normal light and ensure the duration of light exposure.
Foundation construction:
1. The foundation of the light pole construction should be reliable and strong enough to ensure the stability and safety of the light pole.
2. The construction foundation should be flat, reliable and safe, and avoid installation in potholes to prevent water accumulation and damage to the battery and controller.
3. When installing embedded parts, pay attention to one side being parallel to the road, the screws should be exposed to the ground, not too high or too low, and it is best to use a small sleeve to cover the screw rod when pouring concrete to ensure that the screw rod is not stained with concrete.
Avoid direct light sources and heat sources:
1. There should be no direct light source on the
Solar Street Lights panel to avoid identification errors in the lighting control system.
2. Avoid placing the lamps very close to heat sources to avoid affecting the life of the lamps.
Lightning protection and grounding protection:
1. The design of grounding protection and lightning protection facilities must strictly comply with the "Building Lightning Protection Design Code" to ensure the safe operation of
Solar Street Lights.
2. All
Solar Street Lights poles and electrical equipment need to have complete lightning protection and grounding protection measures.
Installation of light sources and panels:
1. The angle and direction of the panels during installation should be based on the principle of accepting maximum lighting conditions and cannot be installed at will.
2. Avoid wearing metal jewelry when installing the panels to avoid impact on the panels.
3. The connection between the two wires should be designed to prevent falling off and leakage, and the firmness of the screws must be appropriate.
Spacing and height:
1. Pay attention to the spacing between
Solar Street Lights, calculate the distance according to the width of the road surface and the height of the pole, and it is advisable to have no shadow in the middle.
2. The height and spacing of the light poles should be reasonably planned according to the actual situation to ensure the lighting effect and coverage.
Safety warning and protection:
1. When installing
Solar Street Lights, warning reminders should be made on both sides of the installation route to inform pedestrians to pay attention to safety.
2. The installers should do a good job of their own protection, wear insulating gloves, insulating shoes and other protective equipment to avoid accidents at the construction site.
Installation acceptance
1. After the installation is completed, the acceptance work should be carried out to check whether the accessories such as street light poles, lighting fixtures, solar panel components, lighting controllers, batteries, etc. are complete and meet the design requirements.
2. Check whether the
Solar Street Lights meet the expected height, lighting brightness and other requirements during the trial operation.
Follow the above precautions to install
Solar Street Lights to ensure its normal operation and extend its service life, while improving the lighting effect and safety.
