< img height="1" width="1" style="display:none" src="https://www.facebook.com/tr?id=318636409624663&ev=PageView&noscript=1" />
Home
About
Products
Application
Exhibition & news
VIDEO
CONTACT
English
English Spanish

Frequently Asked Questions about Solar Road Studs During Installation (2)

Date:2022-08-25
Glue:
Mixing glue, epoxy resin, glue curing agent, and cement are very viscous after proportioning, especially in winter, it is difficult to mix and move manually. exert its curing effect.

Using glue, apply the glue to the road surface and press the Road Studs firmly. The dosage must be reasonable, too little, the Road Studs will not be pressed firmly; too much, the glue will be wasted and the reflector will be easily stained.
Road closure:
Epoxy glue can only cure after 6 hours, so it has to be closed for 6 hours.

Road Studs special attention to the problem:
1) The drilling is too shallow, and the bottom surface of the Road Studs cannot be fully contacted with the ground, which affects its firmness. Therefore, the drilling depth must follow the principle of nail foot + 1 cm.
2) The holes are too thin, and the nail feet are difficult to install. Therefore, you must choose a reasonable drill bit for drilling.
3) Install Road Studs without removing the ash generated during the drilling process. As a result, the Road Studs are not firmly glued and fall off easily.

It can be seen that choosing a smooth and clean road surface, choosing the appropriate glue, sufficient and uniform glue, and closing the road for 6 hours are the major steps that should be paid attention to in the installation of Road Studs.
Copyright © Henan Ruichen Traffic Equipment Co., LTD All Rights Reserved
   Privacy Policy    Technical Support :coverweb
whatsapp
Phone
Email