For
Solar Road Studs with spikes, the hole diameter of the hole should be 4mm larger than the diameter of the spikes, and the depth should be 5mm greater than the length of the spikes. The dust in the hole should be blown off with compressed air, and then the mixed glue should be plugged and smashed into hole. Main equipment used: electric hammer, greasy knife, gloves. Curing and maintenance: Changan brand
Solar Road Studs can be well cured at room temperature and low temperature. If the curing temperature is about 25℃, it can be put into use in 16 hours; The anchorage force continued to increase with time.
Solar Road Studs should not be disturbed within 6 hours after being pasted and fixed. Matters needing attention: Whether the sticking surface is handled as required, whether the glue ratio is accurate, whether it is stirred evenly, whether the glue layer is even and dense determines the quality of the sticking effect. Nano anti-settling material is added to the structural adhesive, but it is a good habit to check whether the
Solar Road Studs adhesive in the packaging barrel is precipitated before each use.
The recommended mixing time should be guaranteed, and it should be extended for another 3 minutes during winter construction. A and B glue dispensing tools shall not be mixed. The
Solar Road Studs glue that cannot be used up once in the packaging drum should be re-closed and stored in a tightly sealed container. The average temperature of the construction site is lower than 0°C, and the adhesive can be preheated to about 30∽50°C by heating methods such as iodine-tungsten lamps, electric furnaces or water baths before use. Care should be taken not to allow water to be mixed into the bucket.
It is a non-toxic grade material, but individual components are irritating to the skin and eyes before curing, and the
Solar Road Studs adhesive is not easy to remove after curing, so the construction personnel should pay attention to appropriate labor protection, such as safety helmets, work clothes, gloves Wait. After direct contact with human body, rinse with clean water. The higher the ambient temperature around
Solar Road Studs, the larger the amount of glue dispensed each time, and the shorter the operating time. Estimate the amount of each dispensing during the pot life to avoid unnecessary waste. Shelf life: at least 8 months from the date of production (stored in the original package and sealed in a dry place at room temperature).
