< img height="1" width="1" style="display:none" src="https://www.facebook.com/tr?id=318636409624663&ev=PageView&noscript=1" />
Home
About
Products
Application
Exhibition & news
VIDEO
CONTACT
English
English Spanish

How to install Solar Road Studs to be waterproof ?

Date:2021-09-25
   
     1. First of all, it is necessary to ensure that the Road Stud Lights itself does not leak water, and the waterproof level of Solar Studs must be tested to ensure that the waterproof level is above IP67. Waterproof inspection method: Put the Solar Road Studs in a water basin, the glass surface is 5cm away from the water surface, power on for a test run for 48 hours, during which it will turn on and off for about five or six times every two hours, and check the waterproof condition under the heated and cooled state.
     2. Secondly, the wire connection should be well sealed: the wiring port of the general lighting Road Stud Lights has a special sealing rubber ring and stainless steel fasteners. First, pass the cable through the rubber ring, and then tighten the stainless steel fasteners until the wire cannot be pulled out of the sealing rubber. At the same time, when the incoming wire and the lead wire are connected, a waterproof junction box must be used. After the wiring is completed, the edge of the junction box is glued and sealed or the inside is filled with glue.
In addition, I need to remind everyone that Solar Studs in the lawn area should use trapezoidal column-shaped embedded parts with a small upper mouth and a large lower mouth, and barrel-shaped embedded parts should be used for hard areas, and they should be installed under each buried lamp. Make a permeable layer of gravel and sand. Install and open the cover on the Solar Studs. After the Solar Studs is on for half an hour, cover it to keep the inner cavity of the Solar Studs in a certain vacuum state. Use the outdoor atmospheric pressure to press the lamp cover sealing ring to avoid water leakage! Hope this content is for everyone Can play a certain helpful role!

Let's share the countermeasures for water vapor condensation inside Reflective Studs.
When the moisture returns, the condensed water attached to the indoor wall causes the wall to become wet, and even forms a thin stream of water. The same is true for lighting products. The water vapor that enters the reflective studs will condense on the internal components and adhere to the components, causing long-term corrosion or erosion to the components. You need to find a way to deal with it. Then there will be condensation inside the Reflective Studs. What are the countermeasures? Let's take a look!
Countermeasures for water vapor condensation inside Road Studs:
  People often see water vapor attached to the inner surface of the glass panel of Road Studs. It is very difficult to remove the water vapor inside, just like the water vapor, water droplets, water droplets, water flow etc. that accumulate in the room when the tide returns. The countermeasures are as follows:

  1. Through structural design and process control, prevent the intrusion of water as much as possible.
  2, Road Studs internal key components, especially electronic components, should be sprayed, painted, brushed with three-proof paint, or other hydrophobic substances.
  3. Under the condition of not affecting the normal function of the product, add a substance that can absorb water vapor inside the product, just like the desiccant in the food bag. Of course, this is only effective for a small amount of invading water vapor.
  4. When assembling Road Studs products, ensure that the internal components or air are sufficiently dry to avoid moisture remaining in the product during assembly.
    When such a phenomenon occurs inside Road Stud Lights, it is necessary to take corresponding countermeasures, solve it as soon as possible, and put it into normal use!
 
Copyright © Henan Ruichen Traffic Equipment Co., LTD All Rights Reserved
   Privacy Policy    Technical Support :coverweb
whatsapp
Phone
Email