Double-sided and two-color
Solar Studs is a kind of traffic product. It is installed along both sides of the road surface and uses sunlight to obtain energy and uses LED as the light source. It is used at night or in rainy and foggy weather to indicate the direction of the road. Among them, there are many types of
Solar Studs, here I classify them into two types, one is the bottom with a nail; the other is the bottom is flat, that is, the double-sided two-color
Solar Studs we produce today are A kind of plane.
The following points should be paid attention to in the production of double-sided and two-color
Solar Studs:
1. Be sure to choose a larger LED chip for the LED light-emitting tube. The size of the LED light-emitting chip must be larger and the stability must be stronger. It is better for Solar Studs to use Taiwan's amazing chips.
2. After choosing this LED, be sure to seal the LED well. If you step on your feet and use it for a long time, it is likely to get wet, so the life of this product will end. So when making double-sided dual-color
Solar Studs, Be sure to make the LED sealing very well,
3. When using the potting slurry to seal the entire
Solar Studs surface, it must be made of the best and relatively hard material, that is to say, the pressure resistance of the glue must be very good, otherwise it will take a long time.
Solar Studs components are easily damaged by extrusion when pressed by a heavy truck.
4. Be sure to use pressure-resistant solar panels.
Solar Studs has a solar silicon wafer made in the United States. It is slightly better than ordinary solar panels in terms of compression resistance. Not only is the
Solar Studs solar panel better, his The circuit board must be made of double-layer fiberboard, not cardboard, etc. Many details need to be done better, so you can analyze more, communicate more, and communicate more, thank you!
.jpg)
.jpg)
