Because solar road studs can outline the outline of the road very well, it greatly improves the safety of driving at night. A good solar road studs should have three elements during use: compression resistance, continuous highlighting, firm installation, and Most people pay attention to the first two points during use, but ignore the problem of solar Road Studs installation, resulting in a high fall-off rate in a short period of time. A firmly installed solar Road Studs should pay attention to the following points:
1. Safety protection:
A number of road cones, 2 sets of construction diversion signs, a baton, and one piece of reflective clothing per person. Everyone must wear reflective clothing before departure, and construction signs and road cones must be placed at the construction site
2. Tools:
Electric hammer, disc ruler, batch knife, small glue bucket, chalk, generator, hand electric drill, glue mixer.
3. Products:
Solar road stud (no nail)
4. Auxiliary materials:
Epoxy resin A, B
1. Road closure
Seal the road in advance, place solar construction signs and solar warning lights
2. Positioning
First use a ruler to determine the installation location, install one at 15m, (install according to the drawing) ensure that each location is on a straight line vertically, and at the same time align left and right horizontally, the installation distance is subject to the design requirements, and the road where the solar Road Studs are installed should be flat and clean, so that the solar energy The bottom surface of Road Studs has a large contact area with the ground surface, and the adhesion is greatly increased.
3. Use glue
1) Choose glue. At present, asphalt glue and epoxy glue are mainly used in China. The advantage of asphalt glue is that the curing time is short, but it has a fatal disadvantage: in summer, when the surface temperature reaches 70-80 degrees, it will soften, and when the wheel hits, it will either fall off or stick the softened black asphalt glue on the ground. The surface of the reflective sheet affects its reflective effect. Therefore, epoxy glue must be used to install solar road studs. There are no less than 100 kinds of epoxy resins on the market, but there are only two or three types suitable for Road Studs, and the ratio of the curing agent to it must be reasonable.
2) The glue, epoxy resin, glue curing agent, and cement are very viscous after being mixed in proportion. Especially in winter, it is difficult to mix them manually. Play its curing effect well.
3) Use glue, apply the glue on the road surface, and press the solar Road Studs tightly. The dosage must be reasonable, if it is too little, the road stud will not be firmly pressed; if it is too much, the glue will be wasted and the reflective sheet will be easily stained.
4. After the Road Studs are installed, scrape off the overflowing glue around the Road Studs with a spatula, and clean the road surface.
5. Precautions:
Ruichen Technology warmly reminds you: Do not touch the reflector with your hands, and avoid glue sticking to the reflector, which will affect the reflective effect! It is forbidden to install Road Studs on the road surface with water, humidity and oil stains (easy to fall off). After 4 hours of installation, evacuate the solar warning lights.
