Preparation

    1. Installation Model: solar cat eye road stud RC-SRS-B2
    2. Size: φ112*56mm  (φ4.41*2.20")
    3. Recommended Equipment:

    (1) Drill Machine
    (2) Core Bit
    (3) Drill Rig
a. RUICHEN Traffic recommends using a drill rig to ensure that the drill always
enters the road square to its surface.
b. The drill rig must have a depth adjustment mechanism.
c. The drill rig must be fixed
 

    4. Core Removal and Base Preparation

a. A core removal device is recommended, but hammer and chisel are also
sufficient.
b. Tamper

    5. Adhesive Equipment

Following equipment is needed:
a. Gas burner
b. Melting pot
c. Ladles

    6. Cleaning Equipment

a. Compressed air
b. Broom
c. Cleaning cloth

    7. Safety Equipment

a. Lane closure, warning and traffic direction signs that conform to local traffic laws must be obtained before going on site and set up properly before carrying out installations.
b. Safety gloves
 

Notes

Due to the different areas of application, the method of installation of solar cat eye road stud, as well as the adhesive, must be checked individually for suitability before carrying out the installation.
The installation instructions are only a manufacturer's recommendation and are therefore not suitable for every application. The user must select the appropriate method of installation and the appropriate adhesive in each case at his own risk.
If you have any questions about selecting the correct installation method or the adhesive, please contact us.