In our life, Solar Road Studs are widely used.
Solar Road Studs can be seen in urban or rural areas, highways or country roads, scenic spots or courtyards, which brings great convenience to our night life, but
Solar Road Studs are exposed to the outdoors and are easily affected by the environment and fail, so how should we check and deal with these failures?
1. The whole
road studs light is off:
There are usually four reasons why the whole light does not light up. The common one is that the controller enters the road studs with water, and a short circuit occurs. First, you can see whether there is water stains on the wiring of the controller.
If such a situation occurs, it is most likely that the
road studs controller is damaged due to water ingress. You can use a multimeter to measure the resistance of the two ends of the loop to organize. If the resistance value is too small, it is generally a short circuit. At this time, the road studs controller needs to be replaced.
If there is no road studs controller damaged and short-circuited, then check whether the battery has a problem. You can use the battery pack to measure the voltage. If there is no battery, it should be replaced in time.
If there is no problem with the battery, you can check it again to see if there is a problem with the solar panel. When it is working normally, is there any voltage and current output. If not, then the solar panel needs to be replaced.
If there is no problem with the above, it is likely to be the problem of the light source itself. After powering the LED light source, check whether it can be lit normally and replace it in time.
2. The lighting time of
solar studs is short;
After the solar studs are used for a period of time, even if there is enough light, the lamps may be short-circuited and the lighting cannot be provided normally in rainy days. Just replace a matching battery, and the parameters should be appropriate.
3. The solar studs will not go out after installation:
When installing
solar studs, some users may encounter such a problem, how can the LED light bulb be installed so that it will light up and not go out? At this time, check whether the positive and negative poles of the solar panel are correct. If the positive and negative poles are connected Wrong, you can use a multimeter to measure the voltage of the solar panel to see if it is consistent. If the voltage value is too small, it means that the solar panel itself has a quality problem and should be replaced in time.
4. The lamp beads on the
solar studs are not fully lit:
If the light source is soldered, it is easy to cause such a result. Replace the corresponding lamp beads and the welding is firm. If the light source is fully welded, it is likely that the light source itself has a quality problem, and the entire
solar studs needs to be replaced.
5. The
solar road studs flicker:
There are many reasons for this phenomenon. First, the
solar road studs can be replaced. If such problems occur after replacement, there may be problems such as lines. Check whether the contact surfaces of the lines are in good contact and should be dealt with in time.
If there is no problem with the wires and the light source is still flickering, you need to check the battery. If the battery is in a power-depleted state and the power storage is insufficient, the light source may also flicker. In this case, the
solar road studs battery should be replaced in time.
