When installing Solar Road Studs, you need to pay attention to some matters. Let's take a look at it below.
1. Solar Road Studs are installed on the marking line. The marking line is also a kind of resin material, which is attached to the ground itself, and its connection force with the ground has a certain limit. If the Solar Road Studs are installed on the marking line, the impact force of the Solar Road Studs is completely transferred to the marking line, so that the Solar Road Studs are easy to be impacted off, and the marking line will also be glued off.
2. The installation position of Solar Road Studs is uneven. The direct result of this is that the stress on the road studs is uneven, and the pressure on the Solar Road Studs is almost concentrated on the convex and concave parts. Solar Road Studs are prone to cracking if encountered with heavy tonnage vehicles.
3. The installation location of Solar Road Studs is not clean. The firmness of the road stud depends on the tight combination of the road stud, glue and the ground. If the installation location is not clean, the dust in between will absorb most of the adhesive force of the glue, resulting in weak adhesion of the road stud, and it is easy to fall off when subjected to external impact.
4. The amount of glue used is not enough or too much. If the amount is not enough, the bonding strength of the road stud will be reduced and its service life will be reduced; if the amount is too much, the excess glue will seep out from around the road stud, and it will easily rub on the reflective sheet of the road stud, affecting its reflective brightness.
5. Uneven application of glue. When installing Solar Road Studs, the glue should not only be used in an appropriate amount, but also be applied evenly, so as to ensure that all parts of the road stud are evenly stressed and avoid being crushed due to uneven force.
6. The ambient temperature is not enough when the epoxy resin glue is prepared. Epoxy resin glue is a two-component glue. The glue and curing agent must be proportioned according to a certain ratio, and can only be effective after being evenly stirred. However, because the epoxy resin glue condenses more strongly in low temperature weather in winter, it is not easy to stir evenly, so it must be heated before use to soften the glue before use.
