There are two kinds of lighting modes of
solar road stud lights: continuous light and flashing light. Most of the early solar road stud lights were flashing, and people at that time believed that the way of flashing was more eye-catching and could alert drivers. However, it was later found that this was not the case. The continuous flashing of solar road stud lights made the driver feel anxious, uneasy and uncomfortable. Dazzling light may also affect the driver's vision.
But
Synchronous solar road stud can realize synchronous flashing, which is beautiful and eye-catching at the same time. This synchronous and bright solar road stud lights can be like the Pearl of the night, so that people feel happy. The synchronous solar road stud lights is connected by wires, and the battery and circuit can be replaced. This kind of road stud light is more compression resistant, more stable and longer life.
The traditional solar road stud light has its own system, which can complete photoelectric conversion, electric energy storage and LED flashing. Because there are solar panels, circuits and batteries in the solar road stud lights, it is difficult to achieve a high compression value.
The characteristic of
synchronous solar road stud light is to gather the solar panel, battery and control circuit in each solar road stud into a control box. A control system can effectively control solar road studs within 500 meters. The solar road stud, which only retains the LED and a simple voltage regulator circuit, only has the function of luminescence.
In this way, the inside of the solar road stud is very simple, and the compression value can be very high, which can reach 40 tons. Therefore, the application of synchronous solar road stud light can improve the compressive capacity and service life.
