Because
Solar Road Studs can well outline the outline of the road, it greatly improves the safety of driving at night. A good solar road stud should have three elements during use: compression resistance, continuous highlighting, firm installation, and Most people pay attention to the first two points in the process of use, while ignoring the problem of Solar Road Studs installation, the result is a high drop-off rate in a short period of time. A solid installation of
Solar Road Studs should pay attention to the following points:
1. Safety protection:
Several road cones, 2 sets of construction diversion cards, one baton, and one reflective jacket per person. Everyone must wear reflective clothing before departure, and construction signs and road cones must be placed at the construction site.
2. Tools:
Electric hammer, disk ruler, batch knife, small plastic bucket, chalk, generator, hand drill, glue mixer.
3. Products:
solar road studs
Fourth, auxiliary materials:
Epoxy resin A, B
1. Road closure
Seal the road in advance and place solar construction signs and solar warning lights.
2. Positioning
First, use a ruler to determine the installation position of
Solar Road Studs, install one at 15m, (install according to the drawing) to ensure that each position is vertically aligned in a straight line, and at the same time horizontally aligned left and right, the installation distance is subject to the design requirements, and the road where
Solar Road Studs is installed should be flat and clean , so that the bottom surface of
Solar Road Studs can have a large contact area with the ground surface, and the adhesion is greatly increased.
3. Use glue
1) Glue is used. At present, asphalt glue and epoxy resin glue are mainly used in China. The advantage of asphalt glue is that the curing time is short, but there is a fatal disadvantage: in summer, when the surface temperature reaches 70-80 degrees, it will soften, and when the wheel hits, it will either fall off or stick the softened black asphalt glue on. The surface of the reflective sheet affects its reflective effect. So install Solar Road Studs with epoxy glue. There are no less than 100 kinds of epoxy resin glues on the market, but there are only two or three kinds of epoxy resin glues suitable for
Solar Road Studs, and the ratio with the curing agent must be reasonable.
2) After mixing with glue, epoxy resin, glue curing agent, and cement in proportion, it is very viscous. Especially in winter, it is difficult to use manual work. good performance of its curing effect.
3) Apply glue on the road surface and press the
Solar Road Studs tightly. The dosage must be reasonable, too little, the road studs will not be pressed firmly; too much, the glue will be wasted and the reflector will be easily stained.
4. After the
Road Studs are installed, scrape off the glue overflowing around the
Solar Road Studs with a batch knife and clean the road surface.
5. Notes:
Do not touch the reflector with your hands, and avoid glue sticking to the reflector and affecting the reflective effect! It is forbidden to install
road studs (easy to fall off) when the road is wet, wet or oily. Evacuate the solar warning light 4 hours after installation.