The number one problem with
Solar Road Studs is: not enough compression.
Analysis of the reasons for insufficient pressure resistance:
The
Solar Road Studs products installed on the road have problems in compression, and the
Solar Road Studs products are crushed. This is actually caused by the unreasonable structure. The main manifestations of the unreasonable structure are:
The interior is a hollow structure. Don't think that the aluminum shell is more resistant to compression. In fact, the solar panels of these products are hollow below, or they are not resistant to compression at all.
The solar compression test was done in the laboratory. When the compression was 8.1 tons and 8.9 tons, the
Solar Road Studs broke. It is not even as compressive as qualified plastic road studs, and the compressive value of qualified plastic
Solar Road Studs is 16 tons. Of course, the
Solar Road Studs of this structure cannot meet the 10-ton compression requirement of the Ministry of Communications. General pressure detection equipment can do it.
The hazard of internal hollow is also reflected in the LED lampshade. The LED
Solar Road Studs lampshade is damaged because it is hollow, and then the LED
Solar Road Studs itself will be damaged. How to detect this?
The solar lampshade impact instrument made by our company, the detection method is as follows: after the whiteboard is pulled out, the steel ball falls freely from a height of one meter, and vertically impacts the cover part of the
LED Solar Road Studs to see if the lampshade is damaged.
Facts have proved that the
Solar Road Studs produced by our company are capable of resisting the pressure of 30T.
